Introduction :

Huntsman PU Daltofoam MA 00347 is a HCFC 141 b blown fully blended polyol.It is used with isocyanate

SUPRASEC 5005 to produce CFC free PU rigid foam for discontinuous sandwich panel.

Physical & Technical Properties of PU Daltofoam :

MA00347

Appearance

Viscosity

Specific Gravity

Processing Recommendations :

The chemicals should be adjusted to the correct temperature before use to ensure reactivity and

viscosity is suitable for processing.

It is essential that the polyol must be thoroughly mixed before use.This can be achieved by drum rolling

for minimum of 15 minutes or using a high shear mixer for 5 – 10 minutes.

Processing Recommendations :

Temperature of Polyol

Temperature of Isocyanate (MDI)

It is recommended that the chemicals are mixed as follows :

Daltofoam MA 00347 (Polyol)

Suprasec 5005 (MDI)

Mixing Type

Health and safety :

The appropriate Health and safety advice can be found in the provisional safety data sheet supplied with

this provisional product data sheet.

Storage Recommendations :

The storage life of this product referred to in this data sheet is provisionally 6 months at 20 - 25°C in a

shaded area out of direct sunlight.Keep drums well sealed to avoid ingression of moisture.

Yellow to light brown clear liquid

750 mPa S at 20 °C

1.15 at 20 °C

20 °C

20 °C

:

:

100 pbw

110 pbw

:

Low or High pressure machine.

Huntsman PU Daltofoam MP 52084 is a HCFC 141 b blown fully blended polyol.It is used with isocyanate

SUPRASEC 5005 to produce CFC free PU rigid foam for discontinuous sandwich panel.

The PUF suitable application is -165°C to + 90°C.

Physical & Technical Properties of PU Daltofoam MP 52084 :

:

:

:

Yellow to light brown clear liquid

400 mPa S at 20 °C

1.12 at 20 °C

Processing Recommendations :

The chemicals should be adjusted to the correct temperature before use to ensure reactivity and

viscosity is suitable for processing.

It is essential that the polyol must be thoroughly mixed before use.This can be achieved by drum rolling

for minimum of 15 minutes or using a high shear mixer for 5 – 10 minutes.

Processing Recommendations :

Temperature of Polyol

Temperature of Isocyanate(MDI)

It is recommended that the chemicals are mixed as follows :

Daltofoam MP 52016 (Polyol)

Suprasec 5005(MDI)

:

:

:

:

:

100 pbw

120.5 pbw

Low or High pressure machine.

The appropriate Health and safety advice can be found in the provisional safety data sheet supplied with

this provisional product data sheet.

Storage Recommendations :

The storage life of this product referred to in this data sheet is provisionally 3 months at 10 - 20°C in a

shaded area out of direct sunlight.Keep drums well sealed to avoid ingression of moisture.